![]() ![]() Employment Opportunity / RFQ (Request for Quote).Education - Forum for Technicians and Engineers. ![]() I'm ending this here since I'm guessing you know how to set your tooldepths and such. Now the red toolpath should disappear as it has removed your original dxf line and left you with the. Objects" button on the right hand of the screen. Before you touch anything else, while the original red line is highlighted, click the "Rem. You will be asked if you would like to optimize your G-Code and can click 'OK' or 'Cancel.' Go with 'OK. LZCO is run when switching from Emergency mode to run mode. In Mach3, click RESET once or twice (depending on current mode) to activate LCZO. Then click on the dropbox for "outside", then put your mouse right on the kitten chain in the blue graphics window, click on it, and the whole chain should now turn red.Ĭlick on the "create offset" button and you should now see the blue/green lines to the outside and the original red line on the inside. Use Laz圜AM to generate some G-Code, and load this into Mach3. I chose an 1/8th 2 flute cutter for example. Next, click the offset tab and pick the tool (that you have already setup in LCam) and that should then show up as I have shown in the offset picture I'm showing below. Then, if your coming up with way too many chains, change the connection tolerance number that is in red under the "Extents" tab at the bottom of Lcam window. ![]() When you import the dxf, make sure you always use the "clean" buttom immediately.Very Very important. LCam is a finicky software and there are a lot of tips to get a good looking smooth toolpath. I saw you were havng problems with this and thought switcher helped but lets see if I can help you here. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |